Average Reviews:
(More customer reviews)I bought two of these, one to use as a wireless adapter and one as a repeater. My primary wireless router is a Dlink DIR-622 running the original 1.11 firmware.
Initial setup is fairly easy. The manual is TERRIBLE but you really don't need it for basic setup. Out of the box, or after a hard reset, the device is in "Gateway Mode" with it's DHCP server active and ready to hand out addresses in the 192.168.1 subnet. Connect it to a PC's ethernet port, open your browser to http://192.168.1.220 and you get the configuration screen. From there, it is easy to choose one of the other (3) modes and make a connection to your wireless network.
If you want to make additional configuration changes to other parameters, it gets harder. Once you switch from Gateway mode to one of the other (3), the device no longer acts as a DHCP server for the ethernet port; rather, it effectively becomes a device with a static IP of 192.168.1.220. To make additional configuration changes, you must open your PC's TCP/IP settings and change from DHCP (i.e., "obtain an IP address automatically") to a static address (i.e., "use the following IP address") in the 192.168.1 range. Only then can you again open your browser and use http://192.168.1.220 to access the device.
I setup the first unit in "Adapter mode", configured it for wpa2 and then connected it to my Dish Network 622 dvr. Everything connected and worked perfectly.
I have a large house with my wireless router at the North end, so signal quality at the South end of the house is poor. I configured the second wl-330ge for "Repeater mode" and placed it near the center of my house. Devices in the South end now get excellent signal quality from the centrally located wl-330ge repeater. Devices that used to get 6mbps now hit 35mbps.
Both my units came with firmware 2.0.1.8, but I noticed a newer 2.0.1.9 firmware on the ASUS web site with 11-23-2009 release date. As it mentioned a fix related to Repeater mode, I decided to download it and update both units. I then hard reset and reconfigured them. The one in Adapter mode still worked just fine. The one in Repeater mode ceased to function; devices would connect to it momentarily then lose the connection. After several hard resets and reconfiguration cycles, I gave up and flashed it back to 2.0.1.8, and it immediately started working again. If you are using Repeater mode, I recommend avoiding the 2.0.1.9 firmware.
Click Here to see more reviews about: ASUS WL330GE Wireless pocket access point
ASUS WL-330gE Wireless Access Point combines 4 wireless functions: Access Point, Ethernet Adapter, Gateway and Universal Repeater, into 1 - providing you with connectivity wherever you are.
Click here for more information about ASUS WL330GE Wireless pocket access point
No comments:
Post a Comment