5/19/2011

Buffalo Technology Wireless-G High Power Router and Access Point with High Gain Antenna WHR-HP-G54 Review

Buffalo Technology Wireless-G High Power Router and Access Point with High Gain Antenna WHR-HP-G54
Average Reviews:

(More customer reviews)
Best features for the open-source router firmware enthusiast:
- built in pre-amp on Rx and power amp on Tx. Note that it's not real MIMO as the name might lead you to believe, but the amps make it have "MIMO-like performance" (which I've found is true).
- high gain antenna
- so it has a better S/N ratio than the Linksys WRT54GL, which has been the defacto standard
- support for 'afterburner' protocol (ie. 125 Mbit/s)
- Widely supported by open source firmware, eg. OpenWRT, DD-WRT, Tomato, X-Wrt, etc. And those enable it to have the most wonderful features, eg:
- WMM for smooth VOIP calls using T-Mobile's UMA phones
- WDS for creating a set of cascaded routers blanketing a large area
- Adjusting the power output directly on the Atheros on-board chip
- WPA2 with AES (WPA2 more secure than WPA, AES encryption scheme faster than TKIP), plus the ability to support mixed modes so that older devices that don't support WPA2/AES can use WPA/TKIP)
- and so much more. If you don't know about the merits of open source router firmware, you should read up!
Challenges:
- DD-WRT, OpenWrt, X-Wrt, Tomato or other open source firmware needs to be flashed with TFTP - you can't do it with the web GUI. But it's easy. Just requires timing the transfer as you switch it on.
- Buffalo encrypts their firmware so if you screw it up and want to revert back to Buffalo firmware, you can't just upload it from the web gui of whatever firmware you've installed. You have to upload the decrypted version from DD-WRT's site, and then from there you can upload the latest Buffalo version from their website.
Note: because of the built-in power amp, you shouldn't just set the power output to jam out as much juice as it can. That will make the output signal distort and actually decrease the range. I found that the best S/N ratio is obtained at about 75 mW. (Default setting is 28 mW).

Click Here to see more reviews about: Buffalo Technology Wireless-G High Power Router and Access Point with High Gain Antenna WHR-HP-G54

Buffalo Technology Wireless-G MIMO Performance Router and Access Point WHR-HP-G54

Buy NowGet 25% OFF

Click here for more information about Buffalo Technology Wireless-G High Power Router and Access Point with High Gain Antenna WHR-HP-G54

No comments:

Post a Comment